Go Back  R/C Tech Forums > General Forums > Electric On-Road
LRP brushless motor help >

LRP brushless motor help

LRP brushless motor help

Old 02-17-2008, 02:15 PM
  #1  
Tech Elite
Thread Starter
iTrader: (76)
 
wikedgmc's Avatar
 
Join Date: Feb 2004
Location: San Jose, CA
Posts: 3,258
Trader Rating: 76 (100%+)
Default LRP brushless motor help

I was installing a sintered rotor on one of my 13.5 motors and for whatever reason I cannot get the screws to tighten on the end bell to put the cap back on. I have done this 4 other times but for the life of me cannot figure out what is going on here.

Any ideas?

I would rather figure it out here than send it back to LRP
wikedgmc is offline  

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.