Tamiya Ta06
#2011
took the car apart and will try again, but what I could not undertand even when I swaped the shocks left to right the car still torque steered to the right, droop is even from left to right etc, I am at a loss to understand this car, my 417x is amazing, my ta05 ver ii with ifs and exotek chassis is even faster, but this car is not working how I want it to
#2012
took the car apart and will try again, but what I could not undertand even when I swaped the shocks left to right the car still torque steered to the right, droop is even from left to right etc, I am at a loss to understand this car, my 417x is amazing, my ta05 ver ii with ifs and exotek chassis is even faster, but this car is not working how I want it to
If Caster is different, (L/R), that can also cause it to veer.
#2013
Tech Adept
#2014
Hi guys,
will it be a big thing to get a FOW or Cow for touring? which of the two do you use?
thanks
will it be a big thing to get a FOW or Cow for touring? which of the two do you use?
thanks
#2016
The dimension of the lipo tray is 139.5x48x28mm, shorty pack with r10 behind it is not a problem.
#2018
Tech Rookie
#2021
Just got in a few of the latest TA06 hop ups in. (bottom of page)
Rocker arm bridge, Alum. motor mount adapter, rear spool and alum. rear stiffeners...
Rocker arm bridge, Alum. motor mount adapter, rear spool and alum. rear stiffeners...
#2022
Tech Elite
iTrader: (2)
Got a question for the TA06 Guru's.
Our club along with others in our state run a 21.5 blinky class. The roll outs that are needed are around 62-72mm, or around a 3.1 FDR.
Are these achievable with the TA06? If so, what size 48pitch Spurs & Pinions would be needed?
Also would there be enough travel for the motor to move either back or forwards so the gears can mesh? Unlike a TA05 the spur gear sits higher then the motor much like a old TA04, which was hard to get some gear ratios.
Cheers
Rob.
Our club along with others in our state run a 21.5 blinky class. The roll outs that are needed are around 62-72mm, or around a 3.1 FDR.
Are these achievable with the TA06? If so, what size 48pitch Spurs & Pinions would be needed?
Also would there be enough travel for the motor to move either back or forwards so the gears can mesh? Unlike a TA05 the spur gear sits higher then the motor much like a old TA04, which was hard to get some gear ratios.
Cheers
Rob.
#2023
Tech Rookie
iTrader: (3)
Just got in a few of the latest TA06 hop ups in. (bottom of page)
Rocker arm bridge, Alum. motor mount adapter, rear spool and alum. rear stiffeners...
Rocker arm bridge, Alum. motor mount adapter, rear spool and alum. rear stiffeners...
#2024
Tech Adept