New Ener-G 4600 Ni-MH Cell
#423
Tech Initiate
Hi Danny.
Is that an "official" confirmation from EFRA? Is it possible for you to post it or send me a copy? So I can give it to the Federation here in Norway, and then have a possibility to use the batteries at the upcoming nationals...
Is that an "official" confirmation from EFRA? Is it possible for you to post it or send me a copy? So I can give it to the Federation here in Norway, and then have a possibility to use the batteries at the upcoming nationals...
#424
Tech Champion
iTrader: (42)
Anybody looking to try these I have a huge sale on going till thursday.. WWW.tmxpress.net awsome cells....
#425
Tech Elite
iTrader: (171)
Join Date: Sep 2003
Location: Brooklyn New York GO HARD OR GO HOME!!!!!!
Posts: 4,362
Trader Rating: 171 (100%+)
On a GFX with 4 cell pack in cyc. mode how do you tell what the AIR's are.Thanks
#429
Tech Elite
iTrader: (171)
Join Date: Sep 2003
Location: Brooklyn New York GO HARD OR GO HOME!!!!!!
Posts: 4,362
Trader Rating: 171 (100%+)
Danny, How do i tell what my IR's are when you cycle a 4 cell pack. I got the discharge # and peak.Volts at the end of the screen you have
RIR
AIR how do I tell what each cell has for IR's after I cyc. them as a 4 cell pack
Thanks George
RIR
AIR how do I tell what each cell has for IR's after I cyc. them as a 4 cell pack
Thanks George
#430
Tech Adept
George,
The GFX only gives you total AIR for the pack, not individual cell resistance. If you divide the total by 4, you get average per cell. This number may be slightly more than label values due to slight increase in resistance from solder joints.
The GFX only gives you total AIR for the pack, not individual cell resistance. If you divide the total by 4, you get average per cell. This number may be slightly more than label values due to slight increase in resistance from solder joints.
#431
Tech Elite
iTrader: (171)
Join Date: Sep 2003
Location: Brooklyn New York GO HARD OR GO HOME!!!!!!
Posts: 4,362
Trader Rating: 171 (100%+)
Thanks Larry That I knew about the ir for the whole pack. So if one of my packs reads 12 for IR's I have to divide that by 4 and come up with 3. So those that mean the the IR's for the cells are 3.
#432
Company Representative
iTrader: (2)
On a GFX you press the mode button until you get the page that has the cycle info numbers called DAT MODE. On the first page of info you will have the PEAK VOLTS , RIR (Relative IR) and AIR (Actual IR). If you press the page button you will have the AVERAGE VOLTAGE at 1 Volt and AVERAGE VOLTAGE at the cutoff and the RUNTIME.
#434
Tech Elite
iTrader: (171)
Join Date: Sep 2003
Location: Brooklyn New York GO HARD OR GO HOME!!!!!!
Posts: 4,362
Trader Rating: 171 (100%+)
Ok Here is what I have as of right now
Pack #1 peak volts 6.05
discharge time 446
sec. 2165
IR's 12
avg. volts 4.68
now I see the IR's that is not as per cell (12) or is that 1.2 IR's per cell Just trying to see if the IR's came up or went down
Pack #1 peak volts 6.05
discharge time 446
sec. 2165
IR's 12
avg. volts 4.68
now I see the IR's that is not as per cell (12) or is that 1.2 IR's per cell Just trying to see if the IR's came up or went down