Tazer 12T ESC Help Setup
Hi Guys, I bought a Sprint 2 with a Tazer 12T ESC in it, but no instructions to setup the ESC. Does anyone have the same ESC and can pm me the setup procedures? Need to reset the ESC and reprogram, but don't know the sequence.
Thanks for the help! |
It should be:
1: turn it on 2:press the button 3:pull full throttle, press the button 4:pull full brake ,press the button 5: trigger at neutral, press the button 6: when turning on, hold button to toggle between fwd only and fwd/reverse |
Do they not have a downloadable manual on Dynamites page ?
You could try this http://www.horizonhobby.com/Products...ProdID=DYN4925 |
Originally Posted by gacjr0
(Post 3892459)
It should be:
1: turn it on 2:press the button 3:pull full throttle, press the button 4:pull full brake ,press the button 5: trigger at neutral, press the button 6: when turning on, hold button to toggle between fwd only and fwd/reverse I did try and look for the manual online and at the Dynamite site, but no luck. Hopefully this works. Thanks again! |
that didn't work, the main thing I need to do is my forward reverse is mixed up. I can change it on my remote, but the throttle trim has to go positive all the way just to keep the car from going in reverse. Thus losing my full throttle capability.
|
Any help pls. need this to work properly! Thanks
|
wire your motor round the other way ;)
|
Originally Posted by Nambino
(Post 3893010)
that didn't work, the main thing I need to do is my forward reverse is mixed up. I can change it on my remote, but the throttle trim has to go positive all the way just to keep the car from going in reverse. Thus losing my full throttle capability.
or go threw the setup and do the process in reverse order for throttle and brake. |
Ok i'll try and do the setup in reverse, but again, im only guessing the setup procedure since i don't have the setup sheet to help me. Last resort will be rewiring the motor. Although the steering is reversed too, so I don't think it's the motor setup thats wrong. I can only plug in the esc and servo one way so I don't think that's reversed either... but either case it's probably not my esc thats wront either. ahhhhh... i'll try it. If not gonna switch to a digi Airtronics I have on my truggy and just get another Spektrum R/X for it.
Thanks for all the help! |
Have you got it yet?
I went and looked at my instr sheet and what I put down was right. The Tazer doesnt care if the thr channel is standard/reversed. |
Thanks It did work! this site is great, I really appreciate all the help! Thanks again!
Don |
All times are GMT -7. It is currently 07:05 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.