popsracer

Guys;

'Buy HPI' has the 6mm clamping Hex Hubs back in stock. I ordered mine last night. 'Tower' is still out of stock.

rc-zombies

iTrader: (9)

I ordered mine 2 months ago when it showed it in stock...and still haven't recieved it...
I hope your order gets delivered..

I ended up ordering the Integy/Atlas ones... 6.2 for the front and 5.2 for the rears...

JDM_DOHC_SiR

iTrader: (31)

Give you all a little heads up on the 6mm ones.... You can use the Older Pro3 ones to thats what I did because I had a set laying around after I sold my Pro3 Hara. a while back
-Dave

tomdav

iTrader: (44)

Ordered knuckles, hubs, 2.0 and 2.5 deg sus mounts, and even got some steel universals. This was from Rainbowten. They showed suspension arms as being in stock but they are also on backorder. Now I'm worried. At least the shipping was cheap, 13 bucks EMS. Thats also with four pair of sorex's.

JusBox

iTrader: (1)

any chance you know where to pick up the pro 3 hubs? I haven't had much luck in finding any.

JDM_DOHC_SiR

iTrader: (31)

Have you tried Stormer Hobbies ?? or Hot Bodies..?
-Dave

VenomWorldOrder

any 6mm hex clamps will fit, from any brand. if you don't care about colour you can get the 3 racing clamps for the mtx3, or v1rr or fwo5 or the mugen seiki clamps for the mtx3.

Super Steve

iTrader: (9)

I bought out the suspension arms from R10!

Actually, RC Zombies did, so blame him

rc-zombies

iTrader: (9)

Zombies HS is now open... j/k
only 1 set left that I'm saving for my self...

the Pro3 hex hubs are #72036 same ones sold on Buy HPI...that they always show in stock...but never is....

Highly recommend getting the Integy/Atlas version...they are Purple. if you're running wide track in front and narrow rears get 1 set of each 6.2 and 5.2mm hubs. this you'll have 3 sets of hubs in different thicknesses..if you include the stock 4.7. you may not need those spacers any more... just change hubs and your wheel will be more secure.

coastaltony

iTrader: (13)

RCZ Tell me what you have to sell. I need a few things.

onnetz

what dish rims will fit on the pro 4?
I noticed hpi only has 24mm ones..

coastaltony

iTrader: (13)

onnetz, good question.
I have been using some Pro-Line rims.
Most of todays races use Take Off pre-mounted CS-27's as a "spec" tire. I'd like to hear from others.

rc_square24

iTrader: (9)

why does my setup system(hudy type) shows that one side of my rear axles as 2deg(exactly) and the other as 3deg.

the car is new, stock parts so the 2deg side should be 3 instead of 2.

anyway to fix this or its my systems problem? im using the integy made set.

i also found that on both diff cases there were material scratched off where the beveled gear spins closest to, even with one shim on the bearing.

this is what i did

rc_square24

iTrader: (9)

this was how the gearbox was scratched

rc_square24

iTrader: (9)

top half