4LikesTamiya TRF416 / TRF416WE / TRF416X
10-19-2010, 12:46 PM
#9931
Hi everyone.
With the Smoken-Fx chassis I had the same problem. In my the hole were not off-center than the original but the belt most shortened. I slightly loosened the belt and everything went well.
With the new chassis and Spec-R diff in my first indoor race in this season I take the final "A" and I ended up 5th in the overall standings.
Good result if we think that for the first time I raced with the new chassis and the new diff.
Enrico from Italy
With the Smoken-Fx chassis I had the same problem. In my the hole were not off-center than the original but the belt most shortened. I slightly loosened the belt and everything went well.
With the new chassis and Spec-R diff in my first indoor race in this season I take the final "A" and I ended up 5th in the overall standings.
Good result if we think that for the first time I raced with the new chassis and the new diff.
Enrico from Italy
10-19-2010, 01:12 PM
#9933
Originally Posted by artwork
Quote: Originally Posted by Raman Could someone kindly give me the link for the aftermarket gear diff for the 416. Thanks http://www.spec-r.com/specrr2/
10-19-2010, 01:52 PM
#9934
10-19-2010, 05:29 PM
#9936
For those of you that run the smokem fx chassi make sure that the chassi isnt bent like a banana when assembled. We had two chassis that ended up like this and had to file the topdeck quite a bit on both ends and enlarge the front holes in the topdeck to line them up with the bulkhead holes. The chassi seems to be around 0.5mm shorter than stock tamiya one.
)
10-19-2010, 06:36 PM
#9939
For those of you that run the smokem fx chassi make sure that the chassi isnt bent like a banana when assembled. We had two chassis that ended up like this and had to file the topdeck quite a bit on both ends and enlarge the front holes in the topdeck to line them up with the bulkhead holes. The chassi seems to be around 0.5mm shorter than stock tamiya one.
Is this a fitment issue with Smokem FX?
Im considering Smokem but after reading this I'm a lil doubtful...
Thanks!
10-20-2010, 03:05 AM
#9944
no, you had to do the same on some of the original 416 top decks. I only needed to take a tiny bit off the ends to make mine fit nice
p.s. I've added a post on the tweak. It's pretty self explanatory but I'll try take some photos soon
p.s. I've added a post on the tweak. It's pretty self explanatory but I'll try take some photos soon
Last edited by CraigM; 10-20-2010 at 03:18 AM.
10-20-2010, 03:49 AM
#9945
Hole distance suspension blocks
Does anyone know if there is a list somewhere which shows all the center to center distances on tamiya suspension blocks?.
If this isn't available maybe someone could be so kind to measure some of the blocks?.
I want to convert my T3 to a tamiya steering system and the tamiya suspension blocks.
I'm currently ordering all the Tamiya parts but first I need to know which blocks I need to get the same trackwidth as I'm currently using.
Thank you.
If this isn't available maybe someone could be so kind to measure some of the blocks?.
I want to convert my T3 to a tamiya steering system and the tamiya suspension blocks.
I'm currently ordering all the Tamiya parts but first I need to know which blocks I need to get the same trackwidth as I'm currently using.
Thank you.
