1/12 L3 question?
#1
1/12 L3 question?
I just bought a rc12 L3 rolling chassis, im just curious on what i put in it as far as size. I guess this would kinda be newbish but i drive 1/10 touring so for 1/12, i just dont know much about. Do i use the same standard size motor and esc for the 1/12 as i do for 1/10?? i know the servo is smaller, but batterys, are they the standard size as 1/10? and i do know its 4 cell for the 1/12...........im new to 1/12 and just want to make sure i get the right things the first time.
thank you
thank you
#2
I just bought a rc12 L3 rolling chassis, im just curious on what i put in it as far as size. I guess this would kinda be newbish but i drive 1/10 touring so for 1/12, i just dont know much about. Do i use the same standard size motor and esc for the 1/12 as i do for 1/10?? i know the servo is smaller, but batterys, are they the standard size as 1/10? and i do know its 4 cell for the 1/12...........im new to 1/12 and just want to make sure i get the right things the first time.
thank you
thank you
#3
ok so the batts and motor are the same as 1/10 scale, cool, now you mentioned brushed.............is it not allowed for brushless in a 1/12
#4
Depends where you race... and if your rear pod will allow it to fit... There is a lot more brushless information for 12th scales in the 1/12th thread. Just gotta dig that info out a little.
#5
thanks for the help man
#6
You should be able to fit a brushless in an L3, most of the new designs have a bigger rear pod for brushless. I have'nt tried it in an L3 but I was able to fit it in my Rev3 speedmerchant and in my CRC 3.1 both of which are close in design time to the L3.
Chris
Chris