Serpent to 1/10th EP Touring Kit S400
07-29-2008, 08:24 AM
#2401
thanks for all d advise guys....i think i will gv a try on my futaba again...i will relocate the esc and receiver position and will also change to analog servo for testing...i will add ferrite core(noise killer) to my wire....
if this still nt settle my problem, i will go for KO 2.4ghz.....
if 2.4ghz still glitch then i think it's time for me to stop this hobby.....
if this still nt settle my problem, i will go for KO 2.4ghz.....
if 2.4ghz still glitch then i think it's time for me to stop this hobby.....
07-31-2008, 04:26 AM
#2403
funnily this glitch problem only happen on certain track n mostly on the certain same sopts... i'm having glitch problem on the same track as KSCHU too... i've changed tx, module, rx, xtals, i never switch brand yet... still using futaba but i'll try another module, or time for spektrum maybe... hate to buy so many receivers again...
08-01-2008, 02:40 PM
#2404
That is the first time I've seen that TFRacing top deck. Looks like it's probably not a bad option for the people who have been wanting to run the large lipo packs in this car. Serpent will have their new parts out before long, but I that topdeck should be fine until then...
Will you be attending the IIC? Why does your sig say Tamiya TRF now?
08-01-2008, 03:47 PM
#2405
Tech Fanatic
Regarding Randy, i will like to thank him for his hard work and effort. The reason why he is moving to another brand is because he is willing to race Offroad and the company that is willing to support him have an EP sedan and is part of the deal. He should be publishing something about it shortly.
I wish him good luck and all the best. Maybe he will be able to race a S120 soon
08-04-2008, 09:28 PM
#2415
What is peoples starting setup with the gear diff, 6000 oil with only 1 pair of gears?
And what other changes do you make, it seems to diff out a lot more than a ball diff, feels like it needs to keep the rear end flatter to prevent the wheel unloading.
Thanks
And what other changes do you make, it seems to diff out a lot more than a ball diff, feels like it needs to keep the rear end flatter to prevent the wheel unloading.
Thanks