DPD issue
#1
Tech Adept
Thread Starter
DPD issue
Is it normal on the dpd for the first cell to have the highest ir than any of the other cells in the pack?I tried a couple packs and the first cell is always the highest.
#2
simple , the first cell is the one that takes the most abuse of all and goes down the line from there
#4
Tech Adept
Thread Starter
But it is a brand new pack and hasent been run.Is it maybe because it hasent been cycled enough?
#5
yes , does goes into 5amp linear mode after the very first cell hits 0.9v , why dont know , but i do know if u got a brand new pack you should charge it 1st then
discharge it to 0.9v on dpd or any other discharger that has a 0.9v cutoff to equalize the pack.
discharge it to 0.9v on dpd or any other discharger that has a 0.9v cutoff to equalize the pack.
#6
also remember , when you buy a matched pack , its not equalize its just been matched so each cell would have run time , volt and IR .