how do i get the bearings out of a oneway?
#1
how do i get the bearings out of a oneway?
i need to get the bearings out of a oneway, and re install them later. reason being i want to anodise the alloy case of the oneway.
can i use a oven and heat the onway unit up and just pop them out?
also, when putting the oneway bearings back in will the heat damage the anodising? what is the max temp i can go before it starts affecting the anodising?
it's a pritty specific question i know, but if anyone can help that would be great.
can i use a oven and heat the onway unit up and just pop them out?
also, when putting the oneway bearings back in will the heat damage the anodising? what is the max temp i can go before it starts affecting the anodising?
it's a pritty specific question i know, but if anyone can help that would be great.
#4
The TRF has always been a great car. SO great in fact XRAY based their last three cars and HPI based their last one on it! Not to mention the Schumacher MSXi2EC
#5
Originally Posted by WRXTC
The TRF has always been a great car. SO great in fact XRAY based their last three cars and HPI based their last one on it! Not to mention the Schumacher MSXi2EC
actually tamiya LITTERALLY based their design, (if not purchased the rights infact) from tech racing. the "Medusa" was the original 41X design.
anyway about the oneway. im a bit scared to try it i don't wanna go blowing a $55 peice. maybe i can email xray about it
#6
or call INA who makes the bearing