CRASH

iTrader: (26)

Yes it does.

Later,

wyd

iTrader: (51)

Damn any secret setup from Larry and Schreff will get you damn close but those guys are killer wheels so I warn you it might not a setup for the weak at heart!!!!!!!!!!!!!!

wyd

iTrader: (51)

WTF you are running on carpet!!!!!!!!!!! Wow I can't imagine you have too many of those in your neck of the woods.

CRASH

iTrader: (26)

wyd,

First your lurking around a TC5 and now your over here in the Losi forum. whats up with that?

Later,

Marcos.J

iTrader: (239)

we dont Mike Boylen has a handful of carpet races a year (like 4 to 6 )

syndr0me

iTrader: (32)

Has anybody been working on a setup for rubber tires on carpet? I think I may take a break from foams this winter, and need somewhere to begin.

Marcos.J

iTrader: (239)

i have a carpet race next week , and im going to start with my current asphalt setup (todd's reedy set up)

syndr0me

iTrader: (32)

I used the weighted LiPo tray last night and it was great. The car weighs about 49.3oz with the Orion Platinum, which gives a little wiggle room to add some weight for ballast and reach the minimum required.

There's a giant gouge in the side of my LiPo case from where the GTB's PCB was shoved into it after a side impact. It looks like it nearly penetrated the hard case. If anybody is considering running a soft case on a LiPo in this car, and you've got the ESC mounted where it could be jammed into the battery, it will probably happen eventually.

wyd

iTrader: (51)

I'm and equal opportunity thread reader/poster.

wyd

iTrader: (51)

I didn't know that. Gives you a little change of pace.

Marcos.J

iTrader: (239)

yes but not much

marvi

iTrader: (82)

is there a way to fit a 20 or 21T pinion on a 128 spur? when i do mine, the center pulley for the front belt rubs on the 3.5R's endbell the lowest i can get without rubbing is a 22T, but im afraid the 3.5 will thermal on me with a 10.65 ratio.

or do i have to get a 130 spur for my ratio to go into the 11's?

Marcos.J

iTrader: (239)

you can either grind down a little bit on the motor where the pulley touches it or just run a 130 or 132 PRS spur, i ginded a little bit of the motor on mine and i can get a 21t with no problems at all,ill get a picture in a minute

Marcos.J

iTrader: (239)

here it is i can actually get a 20t for a 11.71fdr

syndr0me

iTrader: (32)

Wow, that's ghetto.