New X10P4 Touring Car From MLP
#1097
Kim yous is going out USPS ok I Will be shipping it Tuseday. Sorry but it is the best I could do Justin had a family member Stop by and pick his up and I didn't know about it till today! and had to Change his over From Rubber carpet to Foam carpet! Racing!
#1098
Tech Fanatic
iTrader: (28)
No problem I can post pics tonight! Thanks SOO MUCH Marty for getting everything going today Sorry for the late notice this morning and thanks for EVERYTHING. I will hopefully be running tomorrow!! Can't say Thank you enough! Well now I just have to wait for him to get here with my car Well thanks again marty and I will let you know how it goes tomorrow.
Sent you an email Marty. Let me know if you got it.
Sent you an email Marty. Let me know if you got it.
#1099
Well just get some time behind the wheel and Working on turnin! and on power cornering! Stay off the walls and get to know the car I would run a 6 cell at first and then try the 4x2 setup later to get more turn in get so suspension blocks and draw the front suspension back as you need it! once you find what works for you stay with it!
#1103
Tech Elite
iTrader: (10)
Originally Posted by Marty Peterson
Kim yous is going out USPS ok I Will be shipping it Tuseday. Sorry but it is the best I could do Justin had a family member Stop by and pick his up and I didn't know about it till today! and had to Change his over From Rubber carpet to Foam carpet! Racing!
Just to let you know I'll be running both rubber/foam on carpet this season. Thanks!!!!
#1106
Originally Posted by jtracker
Ok now I got the car. Now we want to know if you will have the buggies done next weekend. Stephen says he will pick them up HAHA NA just kidding you've had enough stress for today Pics. coming
OOOOOh Your funny don't stop now your killing me
Now I remember why I need some time off!
#1108
Tech Fanatic
iTrader: (28)
Oh ya Marty I didn't get a battery strap or the mounts for it. Thats one thing we noticed and also the belts were criss-crossed on the center pulley. So I switched them no big deal. Also we noticed that you might want to look into some shims for the center pulley because if you run the vehicle in reverse the center pulleys shifts toward the motor mount and the carbon slipper eliminator rubs on the motor mount. So maybe some shims for it??
#1109
Originally Posted by jtracker
Oh ya Marty I didn't get a battery strap or the mounts for it. Thats one thing we noticed and also the belts were criss-crossed on the center pulley. So I switched them no big deal. Also we noticed that you might want to look into some shims for the center pulley because if you run the vehicle in reverse the center pulleys shifts toward the motor mount and the carbon slipper eliminator rubs on the motor mount. So maybe some shims for it??
Well I race and I do not use a hold down I will need to make one for ya and the belts were crossed ? the first belt is to the front and the outside belt is to the rear but Hey I was in a rush as for the center shaft moving? it didn't when I set it up before but the shims should be on it or they might have come off when I was changing the upper Chassis and took it apart this is why I do not like to rush I guess I should have just waited till I was done and shipped it knowing it would have been right!
Looking on the floor yep there are 4 shims here they came off!
Ok No more rushing things! everyone will get there car when I know it is done and right!