Komodo Dragon
 

Anyone know what the hot brush and spring setup is for the Komodo Dragon motor?

F brushes in mine and the thing is a land missle! :eek:

springs depending on what class you are running, for 1/12 I run green/green or green/red.

I put a pair of 767's in and purple springs on both side's and I was very happy with the speed.. :nod:

The motor worked well im my touring car. I am really liking this KD motor.

Guess I should have mentioned it is for TC. But thanks for the reply Anthony every little bit helps. JW.

F's, 4499's, 767's. Any competition brush with purples +/-

On our track we have to roll it lower than anything else due to the fact that it has sooooo much rpm compared to the other 19T motors.

With Rubber tire and Foam, I stay between a 1.0"-1.04" rollout and it's about the same feel as my best 19T. It winds out like a 12 turn down the straight, and has plenty of torque.

Tim

waht is a good gear ratio for a medium sized carpet track?

-lee

767's with either purples on both or purple on the pos and green on the neg.

around 6.4 I would say, no lower than 5.9

What about gearing for a med-large flowing treated pavement track for a Cyclone touring car running IB4200's???? So far I have found that a 7.05 seemed to work the best 150f but topped out 3/4 of the straight.........I was faster with a Team Scream C2 geared 6.37 and came off at 145f. Just wondering if that is what other people are seeing. I am running F-brushes and red springs on both motors.

i like running the xxx brushes in the KD.i gear it around a 6.5 and use red springs + and -.absolute missile :nod:

the KD seems to like to run 1-2 teeth lower than the c2.it has been faster for me than the c2.

Cool....thanks Jason.

I ran this motor KD motor set up by Ruby motors at 6:1 ,, and found to be a rocket !!!! excellant power bottom end ,, and mad top end speed ... Ill be running this for a while just to give my ruby C2 a rest .. my other sick motor ... :sneaky: :sneaky:

If it is topping out 3/4 of the straight, go up a pinion