HamzaLH

I have a TL-01 and i put a Tamiya Transpeed MS 9T motor and an Mtroniks Viper RVMAX ESC in it the other day ... I cannot get constant acceleration ... It go and stops and glitches SOO much ...

If u slowly accelerate then its ok, but i cant giv it 100% str8 away ... How can i fix this ... Its getting REALLY annoying and i hav a race with my nextdoor neighbour in 2 hrs ...

Any help is appretiated

Hamza

caveman

Try a slower motor,eg 19T. see if it still glitches. Maybe the 9T draws too much current(how many degrees timing?), the BEC of the VIPER RVmax can't give enough power to the receiver when you accelerate hard.

DR.FeelGood

Also check you brushes and springs

Chris

josh69162

iTrader: (3)

Make sure you don't have any lame solder joints anywhere, and that everything is connected good and strong.
-Josh

SpeedDesignz

iTrader: (1)

Glitches in a Electric TC can be sooooo hard to track down, for one thing :

what transmitter are you working with ?
what is your timing set at with yout 9T?
how long since a rebiuld on the 9T ?
how is your gearing ? ( what car ? what surface? what tires? )



can you post a pic of your cars wire routing?

PaZ

ive got the 15 turn version of the viper and mine does that aswell and im running stock. If you give it full throttle when you get up the inside of a car through a corner it stalls for about half a second then it screams away and by then the car you were trying to pass is gone but if you feed it on its fine . I know its not any of my parts because i used to have a LRP v7.1 in and it was fine