3RACING Sakura Advance 2K18 EVO
#376
#377
Tech Initiate
We were testing AluFlex prototype on ETS carpet at the end of the season and car behave way better then on stock cf. No problems with griprols better consistency and it was easier to find proper setup. I also have rdy full plate chassi and alu (7075t6) top deck but i testing will be postponed till next carpet season. Chassis and topdeaks are made for Sakura Advance and Advance Evo.
#378
Tech Initiate
So my alu parts now are black
I have added new photos:
photos.app.goo.gl/6pX6BsCYYEyy8aNx9
I have added new photos:
photos.app.goo.gl/6pX6BsCYYEyy8aNx9
#379
#380
Tech Rookie
SAK-S02
Plastic centre pulley SAK-S02 (uses smaller bearings though) and are 1mm narrower than aluminum.
Two 0.5mm spacers are necessary to leave the pulleys centered and without slack
Two 0.5mm spacers are necessary to leave the pulleys centered and without slack
#381
#382
Had a front driveshaft fail tonight think it may be due to the fatigue of lots of little crashes rather than one particular big crash. Good job they're cheap.
#383
Tech Adept
Posted yesterday on 3RACING's facebook (not sure if it should get its own thread).
#384
Tech Adept
In one of the comments from 3RACING, they said it would be sold as a kit
#385
There was also mention of the Advance 'S' on their Facebook page a few weeks ago
#386
Tech Adept
Such an awesome brand!
I'm still running their older Ultimate and Ultimate 2014 TC chassis...
Eventually I'll add their newer cars to my fleet, their new cars look really good value
I'm still running their older Ultimate and Ultimate 2014 TC chassis...
Eventually I'll add their newer cars to my fleet, their new cars look really good value
#387
Tech Adept
Sad to see they didnt fix the front arms. I hope they also fix the front body post material as it is too brittle, I've had both of them snap in half
#389
Tech Adept
They have their own priorities it seems, ARS possibly not one of them. Could you not use the front arms, c-hubs and knuckles to achieve this? Would give you 4* castor at the rear thou, unless they have a 0* c-hub option.
Good point, never crossed my mind!
#390
Hello everyone. I am new here and also just bought this car kit. (Have not put together yet). I was wondering if anyone has a link to driver setup sheets for black crc carpet ? I am going to be racing this winter in the VTA class. I saw the asphalt setup on 3racing's website probably would start there with setup but would really like to find black carpet setups. Sorry in advanced if this question has been answered.