Go Back  R/C Tech Forums > General Forums > Electric Off-Road
help with new piston and sleeve break in... >

help with new piston and sleeve break in...

help with new piston and sleeve break in...

Reply

Old 11-19-2005, 12:36 PM
  #1  
Tech Adept
Thread Starter
 
Join Date: Oct 2005
Posts: 195
Default help with new piston and sleeve break in...

so I installed a new piston sleeve conrod and pin in my LRP .28
I set the carb to factory setting and I can get it to odle for about a minute and then it boogs down and dies. Raw fuel is coming out of the carb. I tried to lean it out a little but it really didn't help. fuel is spitting out of the carb when its running (just a little spray).

If I give it just a teeny weeny bit of thorttle it immediately dies.

Any suggestions? Does it sound like a possible air leak? I put the backplate from my TT .21 on it so I can do a dill start. Perhaps it is leaking? I remeber someone did the same thing and everything fit pretty well. I am going crazy with this thing!!!!!!

Any help would be appreciated. yes I have a new glow plug and charged battery.
themanimal is offline  
Reply With Quote
Old 11-19-2005, 12:59 PM
  #2  
Tech Regular
 
Join Date: Nov 2004
Location: ep nj
Posts: 403
Default

http://www.rchobbies.org/engine-tuning.htm
mgtman is offline  
Reply With Quote

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Terms of Service