Team Durango DEX8T
#317
I love them, luckily they have only had around 20-30 cycles each so they still have plenty of life left in them yet
#318
Tech Legend
iTrader: (294)
been busy with work lately, how things going everyone?
Anything new on the spring setup front with Tekno springs?
Looking to do full teardowns and rebuilds sometime next week. Moving to a new house mid August with a lot more room, heck maybe put a small section for a track too lol.
Anything new on the spring setup front with Tekno springs?
Looking to do full teardowns and rebuilds sometime next week. Moving to a new house mid August with a lot more room, heck maybe put a small section for a track too lol.
#319
Tech Addict
iTrader: (14)
been busy with work lately, how things going everyone?
Anything new on the spring setup front with Tekno springs?
Looking to do full teardowns and rebuilds sometime next week. Moving to a new house mid August with a lot more room, heck maybe put a small section for a track too lol.
Anything new on the spring setup front with Tekno springs?
Looking to do full teardowns and rebuilds sometime next week. Moving to a new house mid August with a lot more room, heck maybe put a small section for a track too lol.
#323
#324
#326
Yea, it's getting changed next week, I only wired it all up today.........
#328
Tech Rookie
Setup helping hand
Hi guys,
Been reading through this thread and have changed over all the bearings and installed the Tekno springs front/rear. Running a rx8 combo 2250kv motor on a 20t spur. After playing around with the Hotwire I have it set to the mildest profile. Shocks have 40 weight rear and 45 front. Diffs are 5, 7 and 3. My main problem is that the truggy keeps doing wheelies, I have set the anti squat to 1 instead of the standard 2. Any help would be appreciated.
Been reading through this thread and have changed over all the bearings and installed the Tekno springs front/rear. Running a rx8 combo 2250kv motor on a 20t spur. After playing around with the Hotwire I have it set to the mildest profile. Shocks have 40 weight rear and 45 front. Diffs are 5, 7 and 3. My main problem is that the truggy keeps doing wheelies, I have set the anti squat to 1 instead of the standard 2. Any help would be appreciated.
#329
Tech Addict
iTrader: (14)
Hi guys,
Been reading through this thread and have changed over all the bearings and installed the Tekno springs front/rear. Running a rx8 combo 2250kv motor on a 20t spur. After playing around with the Hotwire I have it set to the mildest profile. Shocks have 40 weight rear and 45 front. Diffs are 5, 7 and 3. My main problem is that the truggy keeps doing wheelies, I have set the anti squat to 1 instead of the standard 2. Any help would be appreciated.
Been reading through this thread and have changed over all the bearings and installed the Tekno springs front/rear. Running a rx8 combo 2250kv motor on a 20t spur. After playing around with the Hotwire I have it set to the mildest profile. Shocks have 40 weight rear and 45 front. Diffs are 5, 7 and 3. My main problem is that the truggy keeps doing wheelies, I have set the anti squat to 1 instead of the standard 2. Any help would be appreciated.
#330
Tech Rookie
Thanks for that, yep 20 piņon. It flys but need to control the power output. You mentioned the punch control via the hot wire. Is that the current limiter you are referring to?