2s lipo problems
#1
2s lipo problems
i was driving my slash 4x4 with the castle sct 3800 combo and a bias 2s 25c 5000 and i jumped a snow bank and the battery literally just stopped working. still showing 3.7 in each cell. i used another battery to make sure it wasn't the esc its the battery. it wo.t connect to the charger but i can connect to lvm and reads7.4 all and 3.7/3.7 idk what happened some help would be great.
#4
will not charge and wont do anything.idk whats going on. wires seem tight in there nothings loose.
#5
Tech Master
iTrader: (121)
Sounds like a bad connection inside the pack. I had a 4S pack do that before. After a somewhat hard flat landing, it shut down. Charger wouldn't recognize the pack and it wouldn't power the esc, but all four cells would read on a stand alone balancer. Never did figure it out, but the only thing that made sense was a bad connection between cells inside the pack.
#6
Tech Elite
iTrader: (48)
what kind of plug is on it? Deans / Traxxas?
I would try to replace the plug to see what happens. The Balance lead is what is used to measure voltage, but they main plug is what feeds everything. Even if you voltage test at the plug you can still have a case where it is not making good contact with the male plug on the ESC or charger.
I ran into a lot of this once when I thought could save some $$ on knock off deans plugs.
I would try to replace the plug to see what happens. The Balance lead is what is used to measure voltage, but they main plug is what feeds everything. Even if you voltage test at the plug you can still have a case where it is not making good contact with the male plug on the ESC or charger.
I ran into a lot of this once when I thought could save some $$ on knock off deans plugs.