Yokomo YZ-2
|
|||
#2506
Tech Fanatic
iTrader: (25)
Update! The TLR aluminum horn did not work because it is too short, so full throw left to right was not possible. Threw the stock horn back on, using a slight 3mm gap, it all works nicely and nothing hits the bulkhead. Full throw both sides. The horn is still off centre but not as drastically as per the manual. I'd like to get an aluminum horn however, something in the 21-22mm centre to centre is needed.
#2507
Tech Initiate
Can you put a mip pucks in the Yokomo yz2 ca ?
#2508
MIP does not make an official puck kit for the YZ-2. I am sure you can take measurements and use parts from other puck kits to create a custom one that fits. After switching to Yokomo from AE, I stayed away from the puck kits and don't miss it at all. I never had any issues with the OEM Yokomo parts.
MIP also dropped support for Kyosho so I am back to OEM parts for my SCT as well.
MIP also dropped support for Kyosho so I am back to OEM parts for my SCT as well.
#2509
The Shiny MIP pucks from the Bmax2 fit just fine.
#2512
#2513
Tech Rookie
#2514
Tech Adept
Taking the plunge
Im finally doing it. Im buying two yz2 buggys after getting fed up with the 22 3.0. I race on carpet, bumpy astro, and high grip clay and there are b6 and rb6.6 buggys everywhere. So should i buy two carpet editions and get dirt parts (minus the gearbox as laydown is dominant on our clay) or two dirt editions and get carpet parts. The carpet kits look like they have a little more value in the box to me.
Another question i have is are there any lightweight drivetrain parts avaliable for the yz2? i usuually run aluminum topshafts, outdrives, and dogbones on my stock buggys in order to get the max power i can from my motor...
Another question i have is are there any lightweight drivetrain parts avaliable for the yz2? i usuually run aluminum topshafts, outdrives, and dogbones on my stock buggys in order to get the max power i can from my motor...
#2515
I can't find the 48mm turnbuckles for the rear for sale anywhere. Do people just use the 52mm turnbuckles?
#2516
Tech Regular
Does anyone know if they yz2 uses the same trans idler gear as a b5 or b6?
#2517
Tech Fanatic
iTrader: (11)
#2518
Yeah I saw those but I wasn't looking to buy the ti ones.
#2519
Will the CA edition take a square pack, or is it shorty only?
#2520