Trinity D8 1950 front plate replacement
08-25-2014, 09:55 AM
#1
Trinity D8 1950 front plate replacement
Hey everyone,
I recently purchased an XRay XB9e that was already built with a Trinity D8 1950kv motor (I didn't build it...). During the mains yesterday the motor came loose and caused some havoc.
Anyhow - upon further investigation I discovered that the guy who built it stripped the screw holes in the front plate of the motor, and I guess relied on the threadlock to hold them in there.
I can turn the motor and use the other two screw holes, but am wondering if it is possible to replace the front plate? I've searched online but haven't found anything - any help would be great.
Luke
I recently purchased an XRay XB9e that was already built with a Trinity D8 1950kv motor (I didn't build it...). During the mains yesterday the motor came loose and caused some havoc.
Anyhow - upon further investigation I discovered that the guy who built it stripped the screw holes in the front plate of the motor, and I guess relied on the threadlock to hold them in there.
I can turn the motor and use the other two screw holes, but am wondering if it is possible to replace the front plate? I've searched online but haven't found anything - any help would be great.
Luke
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
