HV Servo / RX8 Gen2 / Hotwire App Question
#1
HV Servo / RX8 Gen2 / Hotwire App Question
Just installed a new Savox SB-2274SG High Voltage servo in my EB48SL. I used the HotWire app to change my RX8 Gen2 Bec voltage to 7.4v. It worked but my Airtronics MT-4 is telling me the actual voltage is around 7.9v. That seems too high. Any feedback on this?
#3
The MT-4 will read the voltage put out by the receiver not the lipo voltage.
It the past when running the BEC at 6.0v my MT-4 will show voltage at 5.5ish unless running an external BEC or receiver capacitor. In those cases it will show voltage super close to 6.0v. Just not sure why it's showing such high voltage.
It the past when running the BEC at 6.0v my MT-4 will show voltage at 5.5ish unless running an external BEC or receiver capacitor. In those cases it will show voltage super close to 6.0v. Just not sure why it's showing such high voltage.