Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
|
|||
#9841
Tech Apprentice
#9842
Tech Adept
iTrader: (11)
Still running stock setup and it's pretty good at my track, but I am looking for side bite. Any recommendations what I can do? I have enough rear traction, but when I go into our S turn, my rear end doesn't stay planted. Sometimes the car likes to get sucked into the outside line if I don't slow down in the groove.
#9843
Still running stock setup and it's pretty good at my track, but I am looking for side bite. Any recommendations what I can do? I have enough rear traction, but when I go into our S turn, my rear end doesn't stay planted. Sometimes the car likes to get sucked into the outside line if I don't slow down in the groove.
#9844
#9845
ok looks like a shorty will fit sideway and move front to back?
#9846
Tech Master
iTrader: (15)
if you buy the mm conversion then when your done you have all the parts for a RM leftover right? So if you buy RM conversion then you get to use all the parts that were left over from the MM conversion and you both cars beside like turnbuckles and other misc. parts it would work right? Not sure about cost tho Its probably a wash...
#9847
I still can't find a reliable screw supplier, anyone know of any? I know there was a Japanese supplier, but I can't seem to find them again
#9849
#9850
#9851
Tech Addict
iTrader: (66)
Check out the R1wurks thread. Sagisi posted a R1 fan mod that will allow you to stay at that same gearing and stay cool. Hope this helps.
http://www.rctech.net/forum/electric...proved-11.html
http://www.rctech.net/forum/electric...proved-11.html
#9853
microfasteners
fastener express
pretty sure there are plenty of these places.
fastener express
pretty sure there are plenty of these places.
#9854