Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
|
|||
#9722
Tech Adept
Mark will your esc fit the other way? your motor wires could be almost cut in half if you did that. And would make no difference in your battery leads.
Anyone try this with a R10 esc yet?
Anyone try this with a R10 esc yet?
#9723
Tech Adept
#9724
Tech Adept
#9725
Tech Initiate
Most of the guys that are replacing plastics are trying the hard composite stuff. From what I know these pieces have less flex than the standard plastics. So with that said they have a greater chance of snapping in wrecks. From what I heard from some of the guys running them is that it allows for the suspension and all the mechanical parts to do their job rather than some of it being soaked up in flex. I personally have only ran the stock plastics and setup and had a few rough tumbles due to high speed traction rolls coming off the straight into a table jump. The worst that has happened was a bent turnbuckle. I am still using the stock ones which are not very durable. Most guys switch over to the lunsford ones (still waiting for backorder).
#9726
selling my 22 4 for a mid b 5 now it all sold
#9727
I have RB6 in mid, will say it turns way better then my B5m. I'm still working on set up to get that turn in that I like.
#9728
Tech Initiate
#9729
I have a b5 now and soon a b5 m
#9730
Any pics of yours? I don't understand fully. Also i'm not a fan of reciever on the right anyone putting it up on a tray or something different?
Mark
Grind all the tray off flush to the vertical sides of the brace . Be careful of the screw locations, don't remove. Cut each thumb screw separate from the tray then remove middle plastic between thumb screws.Each thumb screw is separate and uses the one screw for attachment.
Remove inside legs off water fall.
Slide Esc under water fall, only a 1/4 of Esc fits under the water fall.
Battery in front of Esc.
Receiver on right side of battery.
Note:
Grinding the battery tray is for more flex in front of waterfall to achieve more traction.
Jmoney, test each and tell everyone your results. Prove your theory...
I already done, and posted the results however..LOL
Grind all the tray off flush to the vertical sides of the brace . Be careful of the screw locations, don't remove. Cut each thumb screw separate from the tray then remove middle plastic between thumb screws.Each thumb screw is separate and uses the one screw for attachment.
Remove inside legs off water fall.
Slide Esc under water fall, only a 1/4 of Esc fits under the water fall.
Battery in front of Esc.
Receiver on right side of battery.
Note:
Grinding the battery tray is for more flex in front of waterfall to achieve more traction.
Jmoney, test each and tell everyone your results. Prove your theory...
I already done, and posted the results however..LOL
#9731
what battery pack fit this will a shorty fit
#9732
#9733
#9734
Tech Adept
Here is my inline setup. I went with the battery all the way back. Also i didnt cut out the battery box. I want to be able to switch back and forth to normal setup and inline setup to see what i like best.
#9735
Tech Adept
Yes that is what every one is referring to. I wouldn't recommend removing it as its considered the front mount for your tranny.