Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
|
|||
#8851
#8853
13.5 motor
I want to run a 13.5 with timing, I noticed the manual says to do 81/22 or something similar. I am not sure if this is recommended, or how much timing I should push for with a gearing like that for just a 13.5? Any recommendatios?
equipment is--
Tekin rs gen 2
Reedy mach 2 13.5
equipment is--
Tekin rs gen 2
Reedy mach 2 13.5
#8855
#8856
#8857
Setup
Hey George, Please post that killer setup........puleeeezzzzz
#8858
Tech Master
Cherry isn't THAT bad, you guys just need to:
Last edited by JiuHaWong; 04-24-2014 at 03:37 PM.
#8859
#8860
There's no way I'm the first to "report" this.. but I guess it is so.
http://www.redrc.net/2014/04/mip-b5-...-drive-system/
http://miponline.com/store/mip14230.html
http://www.redrc.net/2014/04/mip-b5-...-drive-system/
http://miponline.com/store/mip14230.html
#8862
#8863
Woo who !
Just got some inserts..
still searching for a b5r ft tower .
Just got some inserts..
still searching for a b5r ft tower .
#8864
Who had inserts
#8865
Tech Master
iTrader: (44)
The only way you're finding inserts online right now is if you already had them back ordered, or you have a stealthy page monitoring program checking every 5-10 minutes across multiple sites like I'm doing
D inserts came into stock on TA's site last week for about 35 minutes before they were out of stock again lol.
A local online site for me finally got some C inserts in yesterday for about 15 minutes before they were gone.
D inserts came into stock on TA's site last week for about 35 minutes before they were out of stock again lol.
A local online site for me finally got some C inserts in yesterday for about 15 minutes before they were gone.