Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
|
|||
#331
Just held one of the official B5 proto types.
Its a b4 with square pack and chassis brace like Centro & a carbon battery strap.
Will be ripping around Trcr in a few minutes..
Its a b4 with square pack and chassis brace like Centro & a carbon battery strap.
Will be ripping around Trcr in a few minutes..
#332
Tech Addict
iTrader: (47)
It's the million dollar question James. Or, I should say, the $70 question. As long as the main gear(teeth) and i.d. of the outdrive bearings are the same size, I don't see why it wouldn't work.
If the axle side of the CVD, is different sized for bearings, length, or something else, maybe MIP will provide a retrofit part. Who knows.
If the axle side of the CVD, is different sized for bearings, length, or something else, maybe MIP will provide a retrofit part. Who knows.
#333
Tech Regular
iTrader: (6)
Ya we will see. I don't want to start any arguments with anyone just wondering. I'll find out when I go to Reedy. Hopefully they will be showing it off more and answering some questions. I like the $70.00 question comment. I'm sure MIP will have new stuff for this car soon. I hope we can use more than just turnbuckles off the B4. Wishful thinking.
#335
I don't have the digital with me ...
Will get images soon , anyone can do the mod.
They hacked out the rails so the square fits & used b44 battery standoffs and straps. A brace is mounted under the rear tower and connects to the b44 battery strap.
was used for determining battery position.
Will get images soon , anyone can do the mod.
They hacked out the rails so the square fits & used b44 battery standoffs and straps. A brace is mounted under the rear tower and connects to the b44 battery strap.
was used for determining battery position.
#338
Tech Master
iTrader: (16)
Did hear they have a special version though that you can take a picture of yourself and have it etched on the bottom, that may not be done yet
#341
R/C Tech Elite Member
iTrader: (10)
If you look at the pictures the new car uses a cvs pin captured by the bearing. Now matter how you look at it either the bone is longer or the out drive is. Something had to take up the difference in length. Now maybe you can get the puck out drives to fit on the new diff and then use your old hubs and bones but that's just conjecture at this point. But just from the picture I can tell it's not going to work without new bones...or using your old hubs and axles.
#343
Oman ...lol
Jake
Got more info about the shocks...
Shaft is is the same, new seal (black) & internals...
Proto type has um.
Jake
Got more info about the shocks...
Shaft is is the same, new seal (black) & internals...
Proto type has um.
Last edited by badaml; 12-30-2013 at 08:05 PM. Reason: Quoted text
#344
#345
.
Last edited by rcuser67898578; 12-09-2023 at 08:29 PM.