Freeski

iTrader: (3)

You can!! Instead of painting on the inside of the body, paint the outside.

I have done it and used Rust-oleam painters touch Ultra Cover Flat Black(comes in a full size can 12oz). It is a nice flat black and basically looks exactly like the photo.

If you can't get your hands on that exact paint, I just went to my local Home Depot and asked for the flatest black spray paint they had. The guy went straight for that can.

Hope this helps.

Ducky162

..... I'm going to bite my tounge and hold off banging my head on the wall. But is anyone else missing the D block for the rear suspension (rear rear mount)??? No where in my kit and I have duplicates of one of the C blocks (2x 3+1) if my build is over I'm not gunna be happy.

"Ducky"

billg1230

iTrader: (8)

I had mine Ducky! Wait, what? You're building a B5?! Haha

Ducky162

Yeah. Saw a kit in stock local... Having a blast, then pow right in the kisser. I'm sure I'll get one in 3-4 weeks if anything becomes available

Wildcat1971

iTrader: (84)

contact AE, I am sure they will send you the missing part.

Jdemonto

Box stock this car is dialed. It holds corners that my b4.2 pushed. The b5 will dominate the tracks. Indoor clay track I used 30* front plate and 5* in the hubs. Other than that box stock.

Jason

Jake S

iTrader: (67)

a buddy got his b5, and the jconcepts rear hexes worked on his, clamped and all.

langsky

iTrader: (27)

OK, I went through this thread, but I am missing where it says what this body is. Can someone fill me in?

mes

Pro-Line Phantom

langsky

iTrader: (27)

And it fits the B5? Does it fit as well as the kit body does?

Jdemonto

The issue is they are wider then the b5 hexes which could push the car past the rear width limits.

Jason

C.Borgia

Team Associated posted two more setup sheets
Chad Duehttp://www.teamassociated.com/pdf/ca...ckside_Due.pdf

Rhode http://www.teamassociated.com/pdf/ca...aven_Rhode.pdf

R-E-A-P-E-R-

iTrader: (13)

Overall a great build, typical AE quality

ccnet101

Very nice!

Jake S

iTrader: (67)

since they worked he can grind them thinner like the team was doing on the c4.2 front hex. its not very much wider.

people began saying their b4.2 rear hex would not clamp, so i was passing this along.