Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
|
|||
R/C Tech Elite Member
iTrader: (12)
got a call from the dr all is good go back in 3 mo i can eat now thank you my god you are awesome for sur
I need $20 more stuff so I can apply a Tower Hobbies coupon. Or, I could add $50 more stuff to apply a different coupon.
What would you guys get for a B5M for $20 or $50? I have some spare front arms already but that's about it.
I'm running a 13.5 motor.
Racing on a pretty tight carpet track with pin tires so super high grip and I already have the stuff below installed.
Gear diff
3 gear tranny
Aluminum rear hubs
Aluminum hexes
Ti turnbuckles
Ti front axles
Sway bar kit
Red front springs
Blue rear springs
Aluminum steering set
What would you guys get for a B5M for $20 or $50? I have some spare front arms already but that's about it.
I'm running a 13.5 motor.
Racing on a pretty tight carpet track with pin tires so super high grip and I already have the stuff below installed.
Gear diff
3 gear tranny
Aluminum rear hubs
Aluminum hexes
Ti turnbuckles
Ti front axles
Sway bar kit
Red front springs
Blue rear springs
Aluminum steering set
Tech Addict
iTrader: (1)
R/C Tech Elite Member
iTrader: (112)
What are these gold rims people are speaking of?
rc cars are like women all the same but so different
what parts are NEEDED for 3 gear tranny conversion? gear case, gear cover. can i use my existing alum top shaft? are the three gears in the case different? if they are, does anyone sell them cut?
thanks.
thanks.
Tech Prophet
iTrader: (84)
New topshaft same gears
Tech Master
iTrader: (77)
3-gear case
3-gear motor plate
3-gear spur cover
3-gear top shaft
(2x) 5x10x4 bearings. The 3 gear aluminum top shaft rides on smaller bearings compared to the 4 gear transmission which uses 6x12x4 .
(2x) diff shims (#1733). The B5M Lite manual lists 2 diff shims and they are correct because when I installed the diff in the three gear transmission case there was a lot of lateral movement between the diff and cases. The shims eliminated most of that play.
Tech Prophet
iTrader: (84)
Tech Prophet
iTrader: (84)
I just pieced a 3-gear transmission together this week. You will need:
3-gear case
3-gear motor plate
3-gear spur cover
3-gear top shaft
(2x) 5x10x4 bearings. The 3 gear aluminum top shaft rides on smaller bearings compared to the 4 gear transmission which uses 6x12x4 .
(2x) diff shims (#1733). The B5M Lite manual lists 2 diff shims and they are correct because when I installed the diff in the three gear transmission case there was a lot of lateral movement between the diff and cases. The shims eliminated most of that play.
3-gear case
3-gear motor plate
3-gear spur cover
3-gear top shaft
(2x) 5x10x4 bearings. The 3 gear aluminum top shaft rides on smaller bearings compared to the 4 gear transmission which uses 6x12x4 .
(2x) diff shims (#1733). The B5M Lite manual lists 2 diff shims and they are correct because when I installed the diff in the three gear transmission case there was a lot of lateral movement between the diff and cases. The shims eliminated most of that play.
Thanks. I meant where did you get yours from. Like do people have a preference for someone's cut gears. A google search only showed CB's cut gears. I don't know if anyone else out there makes them.