Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
|
|||
Tech Champion
iTrader: (73)
The only time I've had this is when I didn't have enough rear bite, and sometimes it would lock up the rears and slide, and feel like no brakes. Try turning them down and see if it improves. If not, check your diff, maybe even your motor to make sure its not loose?
Tech Elite
iTrader: (50)
Is it happening in the same spot on the track or different spots where speed could be less.
Tech Adept
iTrader: (11)
Starting to run stock buggy, what is a good gearing to start with? Reedy Mach 2, medium sized - medium/high traction, indoor track.
Tech Champion
iTrader: (73)
Tech Adept
iTrader: (11)
Thanks Mike! I will start there.
You all need to mention what motor timing to run those gears at otherwise somebody might burn something up.
I'm currently running a mach 2 at 31 deg timing with 35/72.. or 5.35 fdr. Motor and speedo Temps around 125-130f.
I'm currently running a mach 2 at 31 deg timing with 35/72.. or 5.35 fdr. Motor and speedo Temps around 125-130f.
Tech Adept
iTrader: (11)
Does anyone have directions on the Schelle Nova assembly for a B5m? I took mine apart, do not have instructions, or know how to put it back together properly.
Tech Master
iTrader: (75)
#2 drive plate
#3 White pad then spur with side 2(tall side) facing a way from motor plate
#4 another white pad
#5 add drive plate with cut out facing away from motor plate
#6 red pad then the three washers with the cone in the middle facing away from motor plate.
#7 drive plate,spring, plastic end (4mm one)
#8 nut
You can put the red pad in the middle if there low grip conditions.
Tech Adept
iTrader: (11)
#1 Black top shaft adapter
#2 drive plate
#3 White pad then spur with side 2(tall side) facing a way from motor plate
#4 another white pad
#5 add drive plate with cut out facing away from motor plate
#6 red pad then the three washers with the cone in the middle facing away from motor plate.
#7 drive plate,spring, plastic end (4mm one)
#8 nut
#2 drive plate
#3 White pad then spur with side 2(tall side) facing a way from motor plate
#4 another white pad
#5 add drive plate with cut out facing away from motor plate
#6 red pad then the three washers with the cone in the middle facing away from motor plate.
#7 drive plate,spring, plastic end (4mm one)
#8 nut
Posting for Blake.
For all you "light-weight" fans.
B5m complete with:
- cut gears
-shorty servo
-MIP Pucks
-Venom 100c shorty
-ceramic bearings
Momo
For all you "light-weight" fans.
B5m complete with:
- cut gears
-shorty servo
-MIP Pucks
-Venom 100c shorty
-ceramic bearings
Momo
Has anyone bought the 3d printed fan mount. I bought 2, one for each car and they broke in two nights.
Tech Prophet
iTrader: (84)
Tech Master
iTrader: (16)
A buddy dremelled out the top center hole a bit then mounted asc 21942.. xp esc fan using 2 screws to mount the bottom holes through the 2 slots in the waterfall. Works pretty good but just gotta adapt from red jst to servo plug