Go Back  R/C Tech Forums > General Forums > Electric Off-Road
Measuring points on B4 and T4 to set ride heights > Measuring points on B4 and T4 to set ride heights

Measuring points on B4 and T4 to set ride heights

Reply

Old 05-12-2005, 03:24 PM
  #1  
Tech Addict
Thread Starter
iTrader: (5)
 
nwilcox88's Avatar
 
Join Date: Feb 2005
Location: Marysville, Michigan
Posts: 616
Trader Rating: 5 (100%+)
Default Measuring points on B4 and T4 to set ride heights

I was reviewing the Setup sheets on the Associated site.

I noticed the ride height on the http://www.rc10.com/racerhub/setup/r...assic_2005.pdf was set at a hard number for front and rear? Were are the measuring points? There is 10mm difference, I know the chassis does not site this low.

Same with the B4 http://www.rc10.com/racerhub/setup/r...assic_2005.pdf what are the measuring points there as well?
nwilcox88 is offline  
Reply With Quote
Old 05-16-2005, 09:25 AM
  #2  
Tech Apprentice
 
Join Date: Nov 2004
Location: BREA CA
Posts: 96
Default

There is a 1mm differance in front to rear height if you set the car up level. This is due to the rear chassis plate being slightly sunk in when compared to the main chassis.
The measurements are taken just behind the front bumper and just in front of the tranny.
M LANE is offline  
Reply With Quote

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Terms of Service