TLR TEN-SCTE 2.0 Kit Thread
#1111
Tech Master
iTrader: (9)
Hey guys, I recently ordered this kit from my Lhs. Should have it in two weeks or so. I've had the 1.0 sence it came out; been running the castle 3800kv 4 pole and rx-8. That match has worked out fairly well for my use, which is mostly tearing up the woods, and occassionally racing. I woulden't mind having a little more power and control in the motor department. Thinking about the Tekin 4 pole or maby the revtech 4 pole. Which one is better for this car? Or is another motor out that is better?
http://www.falconsekido.com/products/xrm3656sd
#1112
can you get the wheel pins with out buy hexes
#1113
Sensor Wire Length
Okay so I ordered a 200mm sensor wire for this build, and its way too short. The perfect length to go from my RX8 to PRO4 was 275mm. I'll attach the pictures showing how the wires were routed.
#1114
Little known fact the wheel pins are the same as the CVD coupler pins so you can use them interchangeably and swap out the wheel ones for the CVD axle pins when the axle pins start to wear.
http://www.amainhobbies.com/product_...uplers-4-Ten-T
http://www.amainhobbies.com/product_...x-Set-w-Pins-4
http://www.amainhobbies.com/product_...uplers-4-Ten-T
http://www.amainhobbies.com/product_...x-Set-w-Pins-4
#1115
#1117
With the 275mm, there is slack. The 200mm won't reach my esc even if I didn't run it through that wire tunnel on top of the center diff. The rest of my wires only have about 1/2 inch or less of slack. If I run a 550 can motor, my "C" pole wire may be too short.
#1119
#1120
Tech Adept
#1122
Tech Adept
#1125
Tech Addict
I would ask Ryan or Casper about the r10 pro.I think one of them is sponsored by Orion.I know for awhile they were waiting for a update on the software before the r10 could handle the 4 poles correctly.I forget where I read this but I Definately came across it somewhere.So don't pull the trigger until u ask about it.