1/8 buggy body fit guide
#32
If the width of the d8 is close to the rc8.2 then I'm sold on the second link I posted. Only thing now is will it work with it because it is for the tekno v4 conversion? Hopefully it's wide enough.
#34
Good to know. I just came across another thread in the tekno conversion side where a guy said he had the mbx-6 exabyte body on his rc8 with just a little trimming in te front. I pm'ed him trying to get some more info on it.
#35
Ok found out it fit because he was running the tekno conversion. Might look into that myself. Body would be a bonus.
#36
Tech Regular
I found the Losi Pro Line Bulldog body would fit my new Sworks conversion, just had to trim the rear up a bit, other than than it's near perfect.
#37
Well they make a bulldog body for mine just liked the Exabyte better.
#38
Suspended
Anyone know what body fit for serpent 966?
#40
FTW Exabyte 8eight 2.0 fit the 3.0?
#41
I'm wondering too about the dxr8-e body, anyone find anything out?
#45
Tech Fanatic