Speedychris22

iTrader: (68)

Quick questions I'm looking to get 3.5 toe in . Which position should I put the bushings into

jamesbernatchez

iTrader: (50)

Issue? My chassis doesn't have the molded in screw holes to run the battery wires. This seems odd.

Errokk

iTrader: (13)

I dremeled mine out due to them just being in the way. Saw no real use for them.

advpball

iTrader: (30)

Ran mine 13 last night with rear tranny mod of cutting off the plastic on chassis,
very much improvement, can grab throttle coming off of tight corners.Developed slight push but can live with that.just gotta concentrate on better driving. lol

monsterbrad

iTrader: (1)

lets see pics of that modd you did with the back please

advpball

iTrader: (30)

just cut plastic chassis off under rear diff..just leaving aluminum chassis..
drops rear diff down,sorry no pics available.

auto2

iTrader: (7)

hummm maybe a running change? 2014 chassis right? i cut mine off by the esc.

auto2

iTrader: (7)

your talking about the 2013 chassis? the 2014 chassis has a plastic spacer there that you just remove and buy the new hinge pin holders (or grind down the stock ones to sit flat)

Fabulous

iTrader: (42)

That's the XB4 2wd chassis.

advpball

iTrader: (30)

yes 2013 chassis

Pintopint

yes 2WD Chassis multi servo position setting

jamesbernatchez

iTrader: (50)

You think it matters its a 2wd chassis? I don't care about the posts as long as the geometry is correct.

Potoczak

iTrader: (120)

What pinion are you running? Going to be running the same motor.

seth556

iTrader: (43)

I usually run 20/84 or 19/81 with my Reedy 6.5t

Errokk

iTrader: (13)

I run a Tekin 6.5t and I run a 19t pinion. Plenty fast for my indoor track with no timing in it. Track has approximately a 70' straightaway.