Go Back  R/C Tech Forums > General Forums > Electric Off-Road
Blitz Dog Bones too short? >

Blitz Dog Bones too short?

Blitz Dog Bones too short?

Old 09-06-2012, 04:51 PM
Tech Adept
Thread Starter
iTrader: (10)
kid_sublime's Avatar
Join Date: Aug 2012
Posts: 121
Trader Rating: 10 (100%+)
Default Blitz Dog Bones too short?

I desperately needed to change my drive cups on my blitz but couldn't find a stock set anywhere so i decided to go with an MIP ball diff. after installation i realize the bones just fall right out? they were fine before the ball diff i dont get it. do i HAVE to run the cvds with these? can i just use some o-rings in there or something to limit the bones travel?
kid_sublime is offline  
Old 09-21-2012, 05:33 PM
Tech Addict
iTrader: (3)
preciadoalex123's Avatar
Join Date: Aug 2012
Location: San Bernardino County, CA
Posts: 566
Trader Rating: 3 (100%+)

that shouldnt happen, either you installed it wrong or you could try the o rings method
preciadoalex123 is offline  

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off

Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell or Share My Personal Information -

Copyright © 2023 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.