Kyosho Ultima RB6 & RB6.6 Car Thread
|
|||
Tech Elite
iTrader: (105)
Ok,yea I don't have that spacer between the bearings(law253). I think that's why I keep blowing out the inner bearings. Thanks
Tech Master
iTrader: (66)
We all learn that lesson the hard way. That spacer is there to put all the load of tightening the axles on the inner race of the bearing. Without that spacer, you are essentially pushing the inner race one way and the outer race the other. Binds up the balls
Tech Addict
iTrader: (10)
Went back to the 76 spur as recommended and dropped the timing to 10 on the motor. Zero SC timing. Thing got hot. Way hotter than when I was at 30 degrees timing. Dropped to a 20 pinion and still hot. I was at 84/22 so gearing is back close to where I was. I don't see how less motor timing would make it run hotter.
Something seems off here. Any pics I've seen of these motors have the letters lined up with the solder tabs. Mine are way off at 10 degrees and lined up at 30. I don't remember but did it have 30 out of the box? Guh..
I should be aligned to this notch in the case no? If my timing is actually way retarded that would make it hot I assume.
I actually turned some of my fastest laps today but that had more to do with finally making slicks work.
Something seems off here. Any pics I've seen of these motors have the letters lined up with the solder tabs. Mine are way off at 10 degrees and lined up at 30. I don't remember but did it have 30 out of the box? Guh..
I should be aligned to this notch in the case no? If my timing is actually way retarded that would make it hot I assume.
I actually turned some of my fastest laps today but that had more to do with finally making slicks work.
Tech Elite
iTrader: (14)
looks like the glue in the can let loose and something inside shifted. time to send it in
Tech Addict
iTrader: (10)
Tech Rookie
Hi guys.
Does anybody know who makes gearcover for 3 gear gearbox?
Does anybody know who makes gearcover for 3 gear gearbox?
Tech Elite
iTrader: (30)
Tech Master
iTrader: (1)
I've just installed the RC Shox dual stage piston set in the rear of my RB6. it seems like the insert needs something to hold it in place. Does anyone have experience using these? Maybe you can post pics of your setup? I have the insert on top and the base on the bottom. I've watched the videos but it's a little hard to see.
Tech Elite
iTrader: (50)
Tech Elite
iTrader: (50)
3 gear conversion for the rb6, rt6 and sc6
I have a facebook page and group on discussing my 3 gear conversion for the Kyosho line of cars.
go to facebook and search for "3 gear conversion for Kyosho"
go to facebook and search for "3 gear conversion for Kyosho"
Tech Master
iTrader: (15)
Tech Master
iTrader: (1)
Let's hear some steering servo suggestions from the group. I'm leaning towards ProTek 170S or Futaba S9352HV. Probably the Futaba as it seems like it will be faster with lower voltage. I'm running this with my Futaba 4PX system. Thanks!
Regional Moderator
iTrader: (13)
Every single 10th scale car I have ever owned has had Spectrum 6040 put in it, I simply can not kill them whether its 2wd mod buggy, Short course, 4x4 mod buggy, stadium truck... never an issue
Tech Elite
iTrader: (9)
Last edited by RCmayor; 09-08-2015 at 11:18 AM.