R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Electric Off-Road (https://www.rctech.net/forum/electric-off-road-4/)
-   -   SCTE CVD"S? (https://www.rctech.net/forum/electric-off-road/635682-scte-cvd-s.html)

only8ight 06-07-2012 08:56 PM

SCTE CVD"S?
 
hey guys, do you guys replace your center cvd's or replace the pin? the front center cvd worn out really quick !!

8ight-e 06-08-2012 04:04 AM


Originally Posted by only8ight (Post 10834321)
hey guys, do you guys replace your center cvd's or replace the pin? the front center cvd worn out really quick !!

They do wear quick in losi's especially if you don't have the hardened diff outs. You can relpace just the pin if you have the tools if not replace the bone or then entire cvd.

MX304 06-08-2012 05:40 AM

Replace the pin and get the king headz rubber boot so you can pack it with grease. They last a lot longer that way.

JRL 13 06-08-2012 06:33 AM


Originally Posted by MX304 (Post 10835160)
Replace the pin and get the king headz rubber boot so you can pack it with grease. They last a lot longer that way.


you can also squeeze the Losi 8 grease boots over the front and rear CV. They are not as nice as the king headz setup, but are only $7 for 4 and you can pick them up at your local hobby shop.

Grease Boots: LOSA3537

http://www.horizonhobby.com/products...b-2-0-LOSA3537

GiMLit 06-08-2012 09:18 AM


Originally Posted by MX304 (Post 10835160)
Replace the pin and get the king headz rubber boot so you can pack it with grease. They last a lot longer that way.

Can you point me in the right direction for the tool etc for this please.
Much appreciated

Aoh 06-08-2012 10:38 AM

get the Tekno RC center drive shafts, bigger and better. i have them and they show little wear after running them longer than the stock shafts.


All times are GMT -7. It is currently 09:45 AM.

Powered By: vBulletin v3.9.3.6
Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.