what kv and setup you run in your etruggy
#1

hey guys
whats everyone running in there truggy what kv and setup
what brand
whats everyone running in there truggy what kv and setup
what brand
#2

I'm running a tekin combo, rx8 and t8 4038 2250kv on 4S. Smooth and powerfull as hell.
Last edited by alexus; 01-18-2012 at 01:56 AM.
#3

Yea I was thinking cc 2200 or xerun 2200
#4

If I were you, I'll go with sensored, I don't anything about the xerun tough
#5
Tech Rookie
#6

i run a xerun sensored 150a in my rc8t with a 2000kv i think been a while on 4s and its really smooth and powerful. Definetly go sensored though i run unsensored in my rc8be and can really notice the difference
#7
Tech Rookie

i would definitively try to go lower than 2200 kv though, that setup in my experience runs hot. All the guys at my track run 1600kv -1900kv. Just remember if you go low kv and high voltage your system will be more efficient.
#8

I'm running the T8 2250kv in my D8T I can run it geared 16/48 this setup has a lot of speed, a lot more than I was expecting but zero heat problem at all. I'm running traktion drive and mechanical brake though.
#9

I was going to run the xerun 4272SD 2200 kv Sensored combo for truggy and buggy just going take my time do it up get gear time I do that be 3 months
#11

http://www.hobbypartz.com/ezrun-35a-9t-3650-motor.html
I run this set-up in my 1/16 E-revo... Ya baby!!! When that baby hits 88mph you'll see some serious ____...
I run this set-up in my 1/16 E-revo... Ya baby!!! When that baby hits 88mph you'll see some serious ____...
#14

Running a sensored xerun 4274 2000kv motor. Very smooth and has tons of power.
#15

Castle Mamba Monster ESC with a Castle 1518 1800Kv motor running on 4s GensAce 40c 5000mAh LiPo's