sidewinder sct
#1
sidewinder sct
well i think its broken already, all it does is blink green ,and the steering works, was working just fine, and then it just stop, lipo is has a charge of 8.2v so its not my lipo. what should i do, what does the blinking light mean
#3
#4
Tech Elite
iTrader: (71)
set trims on your remote to zero.
with the esc off, hold the trigger at full throttle, should beep,
nce the colors change go to full reverse again wait for the beep
last let go and leave it in neutral, should beep and go to a yellow light after 1 full cycle.
should be good to go.
with the esc off, hold the trigger at full throttle, should beep,
nce the colors change go to full reverse again wait for the beep
last let go and leave it in neutral, should beep and go to a yellow light after 1 full cycle.
should be good to go.
#5
set trims on your remote to zero.
with the esc off, hold the trigger at full throttle, should beep,
nce the colors change go to full reverse again wait for the beep
last let go and leave it in neutral, should beep and go to a yellow light after 1 full cycle.
should be good to go.
with the esc off, hold the trigger at full throttle, should beep,
nce the colors change go to full reverse again wait for the beep
last let go and leave it in neutral, should beep and go to a yellow light after 1 full cycle.
should be good to go.
#6
Tech Elite
iTrader: (71)
http://www.rctech.net/forum/9818634-post2.html
id hold off and call castle as it sounds like yours isnt arming. i think its a calibration issue.
id hold off and call castle as it sounds like yours isnt arming. i think its a calibration issue.
#7
http://www.rctech.net/forum/9818634-post2.html
id hold off and call castle as it sounds like yours isnt arming. i think its a calibration issue.
id hold off and call castle as it sounds like yours isnt arming. i think its a calibration issue.
#8
how is the quality of the sv2?
#9
#10
okay, also could it be that my motor is bad and thats why i keep braking esc?
#11
i got it fixed, brother got castle link and i update the firmware and it allowed me to re-calibrate it