mandy116

iTrader: (20)

Thanx for the pics wildcherry.

Wild Cherry

Your most welcome Mandy....

BSchorr

iTrader: (93)

Hey Wild, I didnt have to grind away at my plate... With leaveing that little lip on the pin block, it causes the lead to be snug against the front side of the tranny.. I guess you can either grind away at the plate and stick it to that, or snug it between the plate and trany. either way, its there!

BSchorr

iTrader: (93)

My FT B4, LRP Sphere Comp 2007, LRP Vector-11 13.5 ROAR Spec, Orion 3800mah 30C, Futaba BLS451 Brushless Servo, Spektrum SR3500 Micro RX, AMB.

Ya ya.. I got the best B4 one on the boards.. I know!

(Will post pics of FT T4 when the rest gets here)

Jason Pelletier

iTrader: (33)

Werd, I got one too and a matching T4.

Looks good.

crazy4wdracer

iTrader: (25)

BSchorr- Nice clean ride, I wish my B4 was that clean.

I will hopefully be getting a FT T4 soon as well.

BSchorr

iTrader: (93)

Thanks. Imageshack picture hosting is acting up right now... Stupid free picture hosting...

Prolly asking yourselves, why I have the huge antenna with the short spektrum antenna, huh? I just like the look of the antenna on the car when I am racing I guess! Makes it look original? lol

Jason Pelletier

iTrader: (33)

Just had a after though looking at your pics. If one of those lead weughts comes undone (happened to me B4 <-- LOL) it will jam your steeringlike you have no servo power. Caught me out once when i was resetting TQ pace... I was so dissapointed. I glue them down now.

BSchorr

iTrader: (93)

Ya, I usualy shoo goo them down, but this batch of AE weights I got, the 2 way tape was really sticky for some reason! I usualy take the crappy white 2way tape off and use the grey Racers Edge stuff, but this will do for now.

BSchorr

iTrader: (93)

...As my FT T4 sits right now, Will be the same specs as my FT B4 above...

Just waiting on #3 shock pistons for the front shocks and front spring tuning set so I can sport the gold springs up front for the setup I want to run at the Missouri ROAR 8 Regionals October 2nd-5th.

(Just wait until you see the finished cars with my new lids! I am hoping to find a good video camera to make a video out of the races.)

mandy116

iTrader: (20)

sweet rides! what do i use to scuff the wing for that flat look?

BSchorr

iTrader: (93)

scuff look? dunno what you mean.

carbon madness

iTrader: (2)

A scotch brite pad http://www.3m.com/us/home_leisure/sc..._scouring.html

Also be sure that you don't get the ones that are scratch free.

mandy116

iTrader: (20)

I seen were wings are not painted but rather a transluscent white. look at tebos, cavs, or maifieids car in th proline ad in the mag.

mandy116

iTrader: (20)

Thank you once again fellas.