tman48

iTrader: (7)

Ok so I received 4 gens ace soft case lipos today to use in my brushless e-revo,I was gonna just put them in the car to make sure they were gonna fit.When I put them in one side will connect to esc but the other is to short.The batteries came with bullet connectors and my esc has deans ultra.So I thought I could buy a bullet to deans ultra connector but I cant find one?So what do I need to do?

Led Finger

iTrader: (8)

solder deans on your lipos.. then rip it up

Divey

iTrader: (119)

^^ Well said. If you are not able to solder then take it to your local hobby shop. They may charge you a small fee. An FYI, in this hobby it would be good to learn how to solder. Key points are a good hot iron and a clean surface.

tman48

iTrader: (7)

Thanks but like I said they are two short.But I got some extra wire im gonna solder on

Divey

iTrader: (119)

Which way do you run the lipos. Flip them the other way if you have to. Run the wires through the vent.

thecman26

iTrader: (112)

Then you could just make your own connector with some wire, bullets, and deans. Pretty easy!

tman48

iTrader: (7)

I got it thanks everybody