tenshock sc401 short course Brushless MOTOR
#511

mine should be here tomorrow



#513

The more time I spend on this hobby the more I think it's 90% driver, 2% car and 8% setup. We are lucky enough to have a guy sponsored by Traxxas and running a slash to keep us grounded.

#514
Tech Apprentice

i seized a bearing somehow and the motor's kinda done. anyone know what size bearing and how to remove the crapped one?
#515

builtrc just got a new shipment in.
you can either get one here: http://builtrc.com/
or through their ebay store: http://stores.ebay.com/builtrcandhobby
you can either get one here: http://builtrc.com/
or through their ebay store: http://stores.ebay.com/builtrcandhobby
#516
Tech Elite

iTrader: (10)
Join Date: Nov 2004
Location: Norwood, OH...and CCRCR and The OhioRCFactory
Posts: 2,974
Trader Rating: 10 (100%+)



Align uses this size bearings on their 450-size mainshafts, so your LHS should have them hanging on the wall if they're helicopter friendly.
#518
Tech Apprentice

5x11x4
#519
#522

Looks good! Let us know what you think after you run it.
#523
Tech Initiate

I've got the 4600 on the way...should get to try it next weekend .....can't wait. Going in the losi scte
#524

i love the 4600 in my SCTE. i'm running 12T but i know i could go 13T if i wanted (maybe would need a fan), but on the tracks i run, there is no need to go up a tooth. at 12/40 it is PLENTY fast.
#525

i agree on the 12t. although mine ran a bit warmer yesterday than my castle 1410 was. and my mmp fan actually came on too w/ the tenshock. seemed to work well though despite the warmer temps