JConcepts Punisher buggy Body for a 8ight-e 2.0
#1
JConcepts Punisher buggy Body for a 8ight-e 2.0
Hi All,
Has any one ran this on the 8ight-e 2.0? is there any issue with the fit over the lipos?
Thanks
John
Has any one ran this on the 8ight-e 2.0? is there any issue with the fit over the lipos?
Thanks
John
#2
Tech Elite
iTrader: (25)
I know a lot of guys are running the Punisher on their RC8BE's with no problem. The side pods look high on the 8ight-E 2.0 version as well. Just make sure if you order from Jconcepts you get your free wing as well.
http://www.jconcepts.net/store/index...roducts_id=282
http://www.jconcepts.net/store/index...roducts_id=282
#3
I know a lot of guys are running the Punisher on their RC8BE's with no problem. The side pods look high on the 8ight-E 2.0 version as well. Just make sure if you order from Jconcepts you get your free wing as well.
http://www.jconcepts.net/store/index...roducts_id=282
http://www.jconcepts.net/store/index...roducts_id=282
#5
I know the Proline Bulldog fits just fine over my lipos.
Not sure on the JC body though
Not sure on the JC body though