J.Pietsch

iTrader: (9)

To clarify, I believe thats only if you are using the one piece stand offs. I'm still on the out of the box setup and it is not an issue. Because of this, I'm ordering up some titanium button head screws and aluminum nuts.

I didn't struggle with the two outer ones, but that inner one with the Dubro ends was an experience. I found that using one of my smaller hex drivers through the bottom to hold the washer in place and then use it to pull the Dubro end in made it pretty easy.

BashemSmashem

iTrader: (42)

They were on the 5000mAh 65c 2s packs (which were working great and staying nice and cool) .
http://www.hobbypartz.com/98p-65c-50...-hardcase.html

The ones I have fit great , you could spread the end of the bullet out a little to make it tighter but then its really hard to get back out .

They fit tight on my 6.0 and 6.6 Nano Techs as well .

BADxDREAMS

Thanks for all the replies. Should I just save and just get the tekin rx8 with Pro 4 motor?

Jake C6R

iTrader: (8)

That's like asking which chassis to get!

Lot's of strong opinions, and there are many good options.

jonasm48

iTrader: (22)

I'm looking to get my scte to slide the rear end around in corners more, I have a rear steer style. Can this be accomplished with diff fluid changes? Take off front sway?

I am new to the scte so it's all stock as far as diff and sway bars.

Thanks

Dano628

+1

Rockthecatbox21

iTrader: (19)

I took my front sway bar off and switched to 2000 wt in the rear diff. My truck was pushing but now i can kind of do a controlled slide around corners.

TCCustoms

iTrader: (9)

Right...I mean we all said what were good options and all but yet still asking after everyone says what they have, like and prices...I mean when u can get 3 or so combos for less with the same if not better results and u wanna pay big money but the money u can save can go to ALOT of other upgrades so at this point it's in yet hands and how much u wanna drop into a system

BlackStarRacing

iTrader: (40)

Simple answer to the chassis debate and motor debate: SHOP YOUR BUDGET..... Buy what you are used to using....buy what the locals around your track are running... AND HELL WE ALL KNOW THERES AT LEAST ONE OF THESE BAD BIATCHESSS AT EVERY TRACK lol....

TCCustoms

iTrader: (9)

Exactly...or if 1 has an option u like and prices are close go with the one that has something u like about it

BlackStarRacing

iTrader: (40)

Question on springs: I see there are the sport packs and i was wondering if you guys that have purchased them are using all or just one set? Just wanted to know if i should buy just a certain strength or the total packs because they are all utilized.

Thanks

HighLife420

iTrader: (49)

Id buy them to have them D, just in case.

BTW, i have a rear set if you want. Can bring them to the track this weekend.

Casper

iTrader: (34)

The racing springs only come in full sets. They are worth it though. Work much better then the stock springs.

Grandturk

iTrader: (5)

Black front and orange rear are the 90% setup. That's what I run, that's what most people run and the setup sheets show.

BlackStarRacing

iTrader: (40)

Thanks guys, ill buy both sets.... Hey HiGHLIFE truck rebuilt loving the TLR chassis thanks for the great buy....now watch out on the track with that evil upgrade of a kit you have.....LOL in my sinister voice (MUST SAY THE MIP KIT DOES LOOK REAL SWEET LOL)