9LikesLosi 1/10 TEN-SCTE ARR 4x4 Short Course Truck Thread
06-05-2012, 02:59 PM
Originally Posted by McD44
DO NOT use the crap bird cage style banana plugs that are included.
06-05-2012, 03:02 PM
Originally Posted by vw addict
Hmmm, interesting.... Is it ok to use those for charging? I have solid plugs on the esc wires
06-05-2012, 03:07 PM
Originally Posted by Jake C6R
Yes, OK for charging. But I don't just because I have OCD.
06-05-2012, 03:26 PM
Originally Posted by theproffesor
alright getting ready to get electronics for my truck. been out so long I see that JR doesnt have a surface radio anymore, too bad my JRX3 was awesome, but then again that was before 2.4 ghz. anyway I have heard there are sometimes glitch issues useing different system parts. I am planning on getting an airtronics mx4 but thinking about either a spectrum or savox servo. has anyone had issues woth these???
06-05-2012, 03:26 PM
Originally Posted by Tanman11
Stupid question............but where? All I see are the stock bodies??? Not at Amain, unless I missed it.
TLR8060
06-05-2012, 03:34 PM
why is it that all the nano batteries have the bullet plugs and not direct wired...i hate these bullet plugs and would rather not run this type of battery but if they are decent batteries i might have to start thinking about switching
06-05-2012, 03:44 PM
Originally Posted by TCCustoms
why is it that all the nano batteries have the bullet plugs and not direct wired...i hate these bullet plugs and would rather not run this type of battery but if they are decent batteries i might have to start thinking about switching
06-05-2012, 03:53 PM
Originally Posted by Casper
The savox is one of the worst servo's for amp draw. It is hard on the ESC BEC. Spektrum are not to far away. This has a little more effect on the ESC you run vs the radio though.
06-05-2012, 03:57 PM
Yeah i only have one nanotec 65C and i wish i had bought more. Good luck to you guys and the race to get them in your cart first when they are in stock again. These things sell out almost instantly. I've been using the regular turnigy 40C in my practice runs and the nanotec 65C for races. The 40C's do get a little hot after a run with my tenshock 401 4600Kv motor.
06-05-2012, 03:58 PM
Tech Master
iTrader: (99)
Servo
I run ae1015 in all my trucks. I've never had a problem.
06-05-2012, 04:22 PM
Ryan Dunford Setup questions
Ryan,
I am running your setup from 2/29/12. It is working well even on an outdoor track. Do you run your shocks emulsion style? I know you run a R10 from Orion whereas I run a RX8 but what current limit do you run?
One more thing, I recently had a bearing fail in the rear diff housing right before the main of a big race. How often do you replace bearings to prevent this from costing you a race? Better yet, how do you check them?
Russell
I am running your setup from 2/29/12. It is working well even on an outdoor track. Do you run your shocks emulsion style? I know you run a R10 from Orion whereas I run a RX8 but what current limit do you run?
One more thing, I recently had a bearing fail in the rear diff housing right before the main of a big race. How often do you replace bearings to prevent this from costing you a race? Better yet, how do you check them?
Russell
06-05-2012, 04:27 PM
Originally Posted by theproffesor
I am going to be running a tekin rx8 and pro4 4600 or sc4x 4.5/5.5 i have looked and dont really see any other servo's with the specs of the savox 1256 orspectrum with same exact stats, which now has me thinking. exact same states, same servo?? any other servo suggestions?
Originally Posted by electricRCrocks
Ryan,
I am running your setup from 2/29/12. It is working well even on an outdoor track. Do you run your shocks emulsion style? I know you run a R10 from Orion whereas I run a RX8 but what current limit do you run?
One more thing, I recently had a bearing fail in the rear diff housing right before the main of a big race. How often do you replace bearings to prevent this from costing you a race? Better yet, how do you check them?
Russell
I am running your setup from 2/29/12. It is working well even on an outdoor track. Do you run your shocks emulsion style? I know you run a R10 from Orion whereas I run a RX8 but what current limit do you run?
One more thing, I recently had a bearing fail in the rear diff housing right before the main of a big race. How often do you replace bearings to prevent this from costing you a race? Better yet, how do you check them?
Russell
He runs emulsion shocks.
He actually has a RX8 in his truck right now and runs the same as I do with 80% limiter. That is as high as I would go with the limiter. If you are on looser dirt and looking to take away some wheel spin you could go down to around 60%
06-05-2012, 04:33 PM
thanks for the info. time to do more research
06-05-2012, 04:35 PM
ok, what about these if the nanos are always out of stock....65c rating but only 5300mah but if you have a few batteries i dont think 5300mah is terrible??
Gens Ace 65c 5300mah
Gens Ace 65c 5300mah
06-05-2012, 04:46 PM
Originally Posted by vw addict
well perhaps it's time for me to upgrade.......
