mamba monster question...
12-26-2010, 03:30 AM
#1
mamba monster question...
buying a used system and trying to figure out if its a v3 or not...any way to tell. it was purchased new aprox 3 months ago. it has a neu style motor.
also...how do you reroute the wire to provide more than 5 volts to the servo?
also...how do you reroute the wire to provide more than 5 volts to the servo?
12-26-2010, 04:09 AM
#2
The V3 has soldered battery cables to the board and the fan area is a bit higher than the capacitor area (on the outside).
The BEC output from the MMM is 5.75V. The Tekin BEC is also 5.75V.
If you wanna run HV servo's, get the Caslte Creations BEC. You can set the voltage between 4.2V and 9.0V.
The BEC output from the MMM is 5.75V. The Tekin BEC is also 5.75V.
If you wanna run HV servo's, get the Caslte Creations BEC. You can set the voltage between 4.2V and 9.0V.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
