Ballistic 550 in 1/8e buggy?
12-14-2010, 11:21 AM
#61
If we didn't need to consider getting ROAR motor approval , spending lots of R&D time and money might be do-able.
Remember, ROAR refused to approve our earliest BL motors because we were the only company making them and "it wouldn't be fair". Same with ROAR approval for our 550 size motors for 4x4 SCTs---wouldn't be fair.
Remember, ROAR refused to approve our earliest BL motors because we were the only company making them and "it wouldn't be fair". Same with ROAR approval for our 550 size motors for 4x4 SCTs---wouldn't be fair.
Not saying ROAR is bad, but seems like their rules hold back advancement sometimes.
12-14-2010, 11:27 AM
#63
12-14-2010, 01:15 PM
#65
We are finishing up our new motor for 1:8 scale. It is 4 pole, 12 slot, sensored. We have not yet prepared our info sheet, but here is a Sneak Peek photo:
Sneak Peek of new Novak 1/8 Brushless Motor
This will be completely user-rebuildable like our current Ballistics.
Sneak Peek of new Novak 1/8 Brushless Motor
This will be completely user-rebuildable like our current Ballistics.
12-14-2010, 02:50 PM
#66
Last edited by NovakTwo; 12-14-2010 at 03:40 PM.
12-14-2010, 03:31 PM
#67
Think I may have just found my next 1/8 motor. Doing an on-road conversion of my Jammin buggy and a low kv Ballistic 550 or Novak 1/8 motor are both very tempting. Glad to see you guys coming out with a 1/8 4-pole!
P.S. I clicked the link for the Ballistic 550 Build-A-Ballistic program and it seems to be a bad link. "Shopatron: We apologize, but the page you requested could not be found."
P.S. I clicked the link for the Ballistic 550 Build-A-Ballistic program and it seems to be a bad link. "Shopatron: We apologize, but the page you requested could not be found."
12-14-2010, 03:32 PM
#68
Novak: Are there any plans for a 12.5mm and 13mm tuning rotor for the 550's?
12-14-2010, 03:38 PM
#69
12-14-2010, 03:40 PM
#70
Think I may have just found my next 1/8 motor. Doing an on-road conversion of my Jammin buggy and a low kv Ballistic 550 or Novak 1/8 motor are both very tempting. Glad to see you guys coming out with a 1/8 4-pole!
P.S. I clicked the link for the Ballistic 550 Build-A-Ballistic program and it seems to be a bad link. "Shopatron: We apologize, but the page you requested could not be found."
P.S. I clicked the link for the Ballistic 550 Build-A-Ballistic program and it seems to be a bad link. "Shopatron: We apologize, but the page you requested could not be found."
12-14-2010, 04:38 PM
#72
12-14-2010, 04:43 PM
#73
12-14-2010, 05:02 PM
#75