What's the trick to getting 1/10 Buggy foams to seat perfectly in the tire/wheel
anyone know any tricks to get them perfect before gluing?
|
trim the inner edges, try to get them beveled. then they won't interfere with the seam between the tire and the wheel.
|
Originally Posted by kaiser
(Post 8187659)
trim the inner edges, try to get them beveled. then they won't interfere with the seam between the tire and the wheel.
|
Thanks guys, also how do you set front toe without a setup station on the buggy?
|
Originally Posted by RC-ZOMBIE
(Post 8187968)
Thanks guys, also how do you set front toe without a setup station on the buggy?
|
for toe i use a wall and my camber gauge push front tires up to wall and use the camber gauge on the wall and not on the counter top. Make sure your servo is centered as well.
my brand new setup station hasn't even been opened. lol |
RPM Toe gauge .
|
Originally Posted by RC-ZOMBIE
(Post 8187633)
anyone know any tricks to get them perfect before gluing?
http://prolineracing.com/images/products/6185-01.jpg |
Originally Posted by b4maz
(Post 8191010)
|
Originally Posted by RC-ZOMBIE
(Post 8192906)
Well there not out yet!!!!
http://prolineracing.com/foam/1-10-c...-rear-inserts/ |
Originally Posted by RC-ZOMBIE
(Post 8187968)
Thanks guys, also how do you set front toe without a setup station on the buggy?
|
AE Is Killer Of All......
Originally Posted by RC-ZOMBIE
(Post 8192906)
Well there not out yet!!!!
|
Originally Posted by Ae*Driver*70
(Post 8193926)
WHY JUST LIMITED PRODUCTION ??:flaming:
"pre-production" In other words, the first batch is small and limited. Full release to follow. Take a deep breath. |
All times are GMT -7. It is currently 06:52 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.