You're right, the NTC3 HD one way is the one that works best with the B44 and 44.1 cars. The tricky part is finding one. I believe AE discontinued them.

The nut is a 8/32...The driver is a 11/32.

Thanks :cool:

Hey guys about to order some koyosho springs and want to know which ones I should run for a med to low traction track. Pretty technical a few jumps.
Thanks
Jake

I was told that most run the yellow front / white rear combo.

+1 ..... Yellow front and white rear

I'm running green fronts and white rear. Absolutely love them wont change. Medium to high bite medium to large indoor clay track. Think it will be perfect in tight tracks as well no push to the front end what so ever!!

blue front, yellow rear. Blue barcode front, green v2 rear. Corner speed is so incredible i beat my last week times by a lap, last week i was getting around top 5 now top 3. I keep getting more attached to it.

Is it me or i have a hard to make my wiring pretty? its a pain in the ass! Some1 post a pic up of some clean wires! :D

http://i258.photobucket.com/albums/h...R/0a8bda4d.jpg

http://i258.photobucket.com/albums/h...R/48e02159.jpg

does anyone make any aluminum shock towers for these bad ass lil buggies yet? i have cracked both of my shock towers (relative nube) and am trying to keep costs down/breaking stuff down to a minimum. thanks

Nice job!!!!!! Wheelman

b44.1
 

hows this? transponder kinda ruined it! lol. ill figure that out later.

I haven't seen an Aluminum one, but are you running a doubled up tower on the front? i bought 2 CF towers, added a little CA, ran screws thru the 4 corners of the tower and tightened them down. Once dried, I gently sanded around the edges ad then CAed the edges of the tower to make sure it wouldn't splinter.

The rear I just left the single tower. I have taken some pretty brutal crashes and towers are holding just fine.



MOmo

Hi, could you show a pic of this? I'm just curious.

Thanks

LOOKS GREAT!! My transponder is under the center drive shaft between the receiver and the servo.