SLASHER: Traxxas Slash with extended Rustler Chasis
#1
SLASHER: Traxxas Slash with extended Rustler Chasis
just thought id share my extended rustler slash. saw many similar conversions on here and thought id try it out. handles great!!!!
i got 1/16"x3/4" aluminum angle from home depot. used #6x3/4" screws and nylon lock washers. only thing i did different from others is that i used the angle on the bottom as well. had to cut it down on the band saw to 5/16", but i am sure it still helps a bit.
love it on the street. hitting the track tonight!
i got 1/16"x3/4" aluminum angle from home depot. used #6x3/4" screws and nylon lock washers. only thing i did different from others is that i used the angle on the bottom as well. had to cut it down on the band saw to 5/16", but i am sure it still helps a bit.
love it on the street. hitting the track tonight!
#3
STRC makes a conversion package that uses the Rusty chassis and extends the rear or the truck. It is heavy annodized aluminum plates, hardware, and new aluminum mounts for the front bumper to the chassis.
It works great. I just tested it this week after completing my conversion.
It works great. I just tested it this week after completing my conversion.
#5
I have the STRC kit and it is sweet. I have run the truck to test once and will race it this weekend; it is much faster, jumps better, and corners much faster and flater than before.
The only concern I have with your set up is the exposure of the batt in the open chassis. If you run lipos, something could puncture the lipo case by coming up through the bottom of the open chassis.
The only concern I have with your set up is the exposure of the batt in the open chassis. If you run lipos, something could puncture the lipo case by coming up through the bottom of the open chassis.
#7
Tech Adept
iTrader: (4)
just thought id share my extended rustler slash. saw many similar conversions on here and thought id try it out. handles great!!!!
i got 1/16"x3/4" aluminum angle from home depot. used #6x3/4" screws and nylon lock washers. only thing i did different from others is that i used the angle on the bottom as well. had to cut it down on the band saw to 5/16", but i am sure it still helps a bit.
love it on the street. hitting the track tonight!
i got 1/16"x3/4" aluminum angle from home depot. used #6x3/4" screws and nylon lock washers. only thing i did different from others is that i used the angle on the bottom as well. had to cut it down on the band saw to 5/16", but i am sure it still helps a bit.
love it on the street. hitting the track tonight!