Dose Voltage cap help with dead spots?
Salutations folks. Ive been having an issue where every so often my steering and throttle will go out for a couple seconds then come back in. several people have said that the bec on my havoc 3s isnt giving enough voltage to the receiver and i need a voltage cap. Dose this sound right, and has this happened to anyone else? im using the following.
Spektrum Dx2.0 w/ sr300 receiver Novak Havoc 3s Ballistic 8.5 sensored ACE 1313 servo 175oz/tq and .13 transit speed using hobby people 5000mah 35c 2cell lipos The voltage cap im speaking of is the one that is made by spektrum and plugs into the receiver. |
It helps.. not always the solution, but good possibility it will be.
Havoc's like to thermal also. |
I am having the same problems with my RX8 and dx3s, I was about to post this same question. I am also loosing both power and steering, I found this
http://www.spektrumrc.com/Products/D...ProdID=SPM1600 I spoke with the people at tekin and they told me to get a capacitor that plugs into the receiver is that the one they are talking about? |
YEP... I use that in my 4wd slash and my ve8
|
In my Hyper 10SC with an HV 550 can and HV Hitec servo on a 2s lipo, I would get dead spots all over the track at every race. Since getting a voltage cap. the truck hasn't glitched once. They're only $10-$20 and are well worth the investment
|
I have been running the rx8 with the dx3s for 3 months and it just started acting up today. Kinda strange
|
mine diddnt start doing this until my last 3 times at the track,im not sure why
|
All times are GMT -7. It is currently 08:23 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.