SC10 gearing for VXL brushless(10.5) set-up
Hey guys I picked up a SC10 roller and I am installing a new VXL system out of a Slash 4x4 in it. My question is spur and pinion gearing for this set up on a short course clay track, spur on truck is an 87t so what would be a good pinion gear choice for this set-up, oh yeah I am running 2s lipo's in it...Thanks:confused:
|
Originally Posted by mopargreg
(Post 7001275)
Hey guys I picked up a SC10 roller and I am installing a new VXL system out of a Slash 4x4 in it. My question is spur and pinion gearing for this set up on a short course clay track, spur on truck is an 87t so what would be a good pinion gear choice for this set-up, oh yeah I am running 2s lipo's in it...Thanks:confused:
If motor temps are fine, try 84/22 for a little more speed. |
I'll try that, I just happen to have a 23t pinion, I tried a 20t and too much low end (wheelies on demand), don't need that for the track.....Really suprised on how well these trucks handle, and thats only a test run in the front yard, can't wait to get it on the track....Might make me park my 2wd VXL Slash.....:eek:
|
Originally Posted by mopargreg
(Post 7001448)
I'll try that, I just happen to have a 23t pinion, I tried a 20t and too much low end (wheelies on demand), don't need that for the track.....Really suprised on how well these trucks handle, and thats only a test run in the front yard, can't wait to get it on the track....Might make me park my 2wd VXL Slash.....:eek:
|
Im not trying to hijack your thread, but I have the same motor/esc/lipo setup for my 2wd slash. Would this spur/pinion combo be good for my slash also, given the same track conditions? Thanks.
|
All times are GMT -7. It is currently 06:26 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.